Home » Forums » Cisco VOIP and SBCS » UC500 Configuration

Key System to PBX

Submitted by ttrentler on Thu, 10/11/2007 - 04:34

I Moved this string of comments to the forums from elseware on the site.  Feel Free to Comment Here

 

Thu, 10/04/2007 - 10:49 — dschlicht (not verified)

re: key back to pbx

cant you go in using CNA and under telopony change from key system to PBX? i know you can go from PBX to key system there.

 

Wed, 09/19/2007 - 23:48 — sjuras

key back to PBX - couple thoughts

The quick, but not so easy way would be to copy the factory config file to "start-up config" and reload. Of course doing so would reset everything to base level.

The other way and perhaps better would be to just modify the running config...the real difference between the KEY and PBX system is how incoming calls are presented (just look at voice-port configs) and how calls are made (again via voice ports and dial-peers). You can still retain the DNs and user definitions.

Granted there's a lot of details that I'm leaving out, but by examing each voice port and how incoming / outgoing calls are handed you get certainly learn better what's going on.

 

Mon, 09/17/2007 - 13:02 — whitfijb

key back to PBX

Anyone know the command or process to reset the UC500 back to its defaults so I can change from key-system back to pbx configuration ?

Mon, 09/17/2007 - 23:25 — Anonymous (not verified)

uc500 default config

You need to locate the default config file in flash. Depending upon the SKU the file name will vary. Following are some examples default config files:
UC520-8U-2BRI-K9-factory-4.2.0.cfg
UC520-8U-4FXO-K9-factory-4.2.0.cfg
UC520-16U-2BRI-K9-factory-4.2.0.cfg
UC520-16U-4FXO-K9-factory-4.2.0.cfg
UC520W-8U-2BRI-K9-factory-4.2.0.cfg
UC520W-8U-4FXO-K9-factory-4.2.0.cfg
UC520W-16U-2BRI-K9-factory-4.2.0.cfg
UC520W-16U-4FXO-K9-factory-4.2.0.cfg

If these files are not in the flash, please downloaded the default config file (matching your SKU) from http://www.cisco.com/cgi-bin/tablebuild.pl/UC520-files

a) In the exec mode copy the default config to the start-up config, for example:
copy flash:UC520W-16U-4FXO-K9-factory-4.2.0.cfg startup-config ? NOTE!!! This is an example
b) You will be prompted "Destination filename [startup-config]?", hit ENTER to confirm.

Once the file is copied (and the CUE comes back ONLINE), reload the UC500, when it boots up, it will be in the factory default mode.

0
Your rating: None
‹ Multiline phones
#1Submitted by jyoo on Wed, 10/17/2007 - 16:17.

thanks

good info. just used it to reset my device back to factory :)

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.