We are having a problem with outbound calls in that the calls are connecting OK, but we (the caller) get a busy tone after 180 seconds and the call disconnects. I notice that the ringing timeouts on the FXO ports is set to 180 seconds, so i think this is the cause of the problem. However, the calls ARE connecting to the outside, so it should not be timing out. I guess that the Ports are not realsing that the call has been answered and treating the call as though its still ringing Any help or pointers would be great. The FXO Port is configured as follows voice-port 0/1/0 Many thanks Paul |
|||
 |
UC500.comCisco Communication Manager Express, UC520, SMB VOIP reference and community |
I tired that, but I get the
I tired that, but I get the following message
Ringing timeout is set to infinity for STCAPP port.
Please configure this value in Call Manager.
Resolved Issue
check this for the problem, I can resolved:
In configure terminal mode:
=============================================
voice-port 0/1/0
timeouts ringing infinity
=============================================
http://www.imdr.com.mx
info@imdr.com.mx
+52-(442)-2424776
Queretaro, Mexico.
Hector Tobilla.
Can you post your configuration
To compare with mine
Not back in the office til
Not back in the office til end of the week - what fixed your problem (if you managed to solve it)
Thanks
Paul
Hi No, I'm afraid I didnt -
Hi
No, I'm afraid I didnt - its still on a TAC with Cisco
Did you have any joy?
Thanks
Paul
Do you resolved this Issue ¿?
I have a similar problem, we have 2 lines in FXO for in and outside calls, and 1 Voip service for international calls, the calls from in and outside from de Voip service works fine, but the FXO in outbound calls cut the calls after 2 minutes aproxim.
Do you resolved the problem ¿?, please post your opinion.